Vrod chin spoiler fitment
by Editor on 03/23/20
I had a few questions in social media about the chin spoiler fitment on our 2003 Vrods. Normally it's not an issue but when you also have a chrome voltage regulator you run into a small problem. It will fit but you really have to push to get the sides of the rad shroud onto the raise bolt holes. It was way to tight in my opinion and decided to trim it as shown in this picture to have it fit properly. I ended up cutting up a plastic lid and made a feeler gauge to have the same clearance on both sides.
Now that the black one is done it's time to trim down the orange chin spoiler, then sand off all that orange paint to have it painted.
Comments (0)
